Autodesk Revit 2016 uses the Autodesk Fabrication MEP configuration data defined in the *.ITM template parts in the current version of Autodesk Fabrication products CADmep and ESTmep.
The Duct Part Editor enables you more detailed control over the duct components and allows you to define detailed dimensions of the part and its connectors.
When placing fabrication parts in Revit 2016, the specifications defined in the Fabrication Configuration define what duct materials may be used.
The specification also controls material gauge (weight), the standard segment lengths, and the connectors applied to the fitting ends.
The *.ITM Template based parts enable detailed control of dimensional values. The connector settings provide you with the ability to configure end conditions.
...View Video Below...
For more information on training and consulting for the various products Ideate services, visit our website at www.ideateinc.com
Ideate Senior Application Specialist MEP/AEC Solutions
Bill has over 25 years experience in applying MEP & AEC design solutions for large commercial companies, this has led to actively develop Autodesk® Revit® implementation strategies, techniques, and procedures for architectural and MEP companies. He has worked for TEECOM Design Group, GTE/GTEL, Greg LeDoux and Associates, and Scottish Power in England. Bill is an Autodesk MEP Implementation Certified Expert, and has been the Lead Designer for several multimillion dollar communication sites which have included structural, electrical, HVAC, conduit, cable plans and equipment layouts. He graduated from the Pasadena Institute of Technology and has a Sustainable Design Certification from the University of California at Berkeley.
Get it. Know it. Use it.
